OrientExpress
Well-known member
Agkirk, there is plenty of room in the enclosure for the LEDs wiring pigtail. Just route it under the LED lamp in an S shape forward and then back to mate with the stock connector. The pigtail is covered in a high temp silicone rubber, so it will not be in danger of melting. Besides the bulbs heat sink only get up to about 150 degrees, but never the less route the wires so they don't touch the heat sink. Everything will fit inside just fine.
As far as beam adjustment there is an 8mm adjustment bolt on the upper rear of the enclosure that moves both the low and high beam assembly up and down. Usually the right side is too low, but either way it is adjustable to suit your needs.
69800, my before and after photos are a little bit deceiving as I don't have the car pointed straight on the road. It's pointed a bit to the left, hence the trees on the left are illumated, and the ones on the right aren't. This does go to show that the beam width is pretty narrow.
As far as beam adjustment there is an 8mm adjustment bolt on the upper rear of the enclosure that moves both the low and high beam assembly up and down. Usually the right side is too low, but either way it is adjustable to suit your needs.
69800, my before and after photos are a little bit deceiving as I don't have the car pointed straight on the road. It's pointed a bit to the left, hence the trees on the left are illumated, and the ones on the right aren't. This does go to show that the beam width is pretty narrow.