The next release will allow +/-10 degree adjustment. Be sure you let the Leaf sit at the same temperature for an hour just to be sure the Dash display has stabilized.Agkirk said:Not sure when you add the Ambient Temp display but it was recently brought to my attention, as well as the ability to "calibrate" that display. My 2015 Leaf dash display was about 10 degrees lower so I cranked in -5 in the cal block. I'm still high by 5 degrees, what am I missing? And where does the data for the LSP Ambient Temp display get generated?
Thanks
LeafSpy reads the raw data from the CAN bus. The Dash display uses that but adds a lot of delay so the reading will take a while to reflect the current outside temperature. Were as LeafSpy responds immediately to any change.