tszukow
Well-known member
Hi again, in general forum I mentioned about poor rear air ducts Nissan design.(check for more details)
Here is my modification and there is significant different when heat starts on the back seat- Heating mode has to be set on "foot".
Tolls needed 5/8 socket wrench.
1.Remove 4 bolts holding front seat frame.
2.move seat back to have room to work-no need to disconnect any wires under.
3.relocate the cable in front of the duct 2 inch away -cut the carpet with sharp blade.
Pics- http://imgur.com/w6sEc38,Kb9EYlD,eyp5u5D,tuyWvvD" onclick="window.open(this.href);return false;
4. I used 3.5 in plastic bottle and molded to the shape over gas oven.
http://imgur.com/TT2HQW1,0YKdvPk,E2DnJvW" onclick="window.open(this.href);return false;
5.Add the Velcro tape and insert new extension duct to the existing and press other end with Velcro to secure to the floor.
http://imgur.com/CZO25hx,lL3BOLt,LCZsswJ#0" onclick="window.open(this.href);return false;
6. Put back the seat with 4 bolts.
Here is my modification and there is significant different when heat starts on the back seat- Heating mode has to be set on "foot".
Tolls needed 5/8 socket wrench.
1.Remove 4 bolts holding front seat frame.
2.move seat back to have room to work-no need to disconnect any wires under.
3.relocate the cable in front of the duct 2 inch away -cut the carpet with sharp blade.
Pics- http://imgur.com/w6sEc38,Kb9EYlD,eyp5u5D,tuyWvvD" onclick="window.open(this.href);return false;
4. I used 3.5 in plastic bottle and molded to the shape over gas oven.
http://imgur.com/TT2HQW1,0YKdvPk,E2DnJvW" onclick="window.open(this.href);return false;
5.Add the Velcro tape and insert new extension duct to the existing and press other end with Velcro to secure to the floor.
http://imgur.com/CZO25hx,lL3BOLt,LCZsswJ#0" onclick="window.open(this.href);return false;
6. Put back the seat with 4 bolts.
