Hello,
My Leaf is a 2015 SV (North America/Canada) with 210 000km.
I currently have the following errors codes in LeafSpy Pro (since purchasing the car) :
• C1106-00 09 ABS RR LH Sensor-2 BRC-68
• C1A70-01 09 BRAKE Brake Control System BR-160
I changed the ABS sensor with new from Amazon. The same codes are still here even with multiple reset. Also it is the sensor fault and not the sensor harness fault(C1102), so it would surprise me that it is a bad wire.
According to service manual, the C1A70 should be solved after the ABS codes, so I would think that I should continue to investigate the C1106.
Before I continue, I was wondering if someone could help me with the following questions :
1. Do someone has experience with these codes?
2. Is a problem with the sensor rotor common? How would I inspect that (with salt on the roads the hub rust on the knuckle and cannot be removed non destructively most of the time)? My idea was to use an oscilloscope to monitor the signal on the wires and compare left and right, but this would not tell me if the sensor or rotor or actuator is bad without a lot of parts swapping. Also maybe I can fit an inspection camera in the hole of the sensor.
3. If it’s not the rotor, the next step would be to replace the ABS actuator. This procedure asks for programming the steering angle sensor. Is the car going to work without this programming(at least to drive it to a dealer or someone with CONSULT)? Will a dealer do this after I replaced the parts myself? It seems to take like 5 minutes according to the service manual... Or is there a way to do it without CONSULT ?
Thanks!
My Leaf is a 2015 SV (North America/Canada) with 210 000km.
I currently have the following errors codes in LeafSpy Pro (since purchasing the car) :
• C1106-00 09 ABS RR LH Sensor-2 BRC-68
• C1A70-01 09 BRAKE Brake Control System BR-160
I changed the ABS sensor with new from Amazon. The same codes are still here even with multiple reset. Also it is the sensor fault and not the sensor harness fault(C1102), so it would surprise me that it is a bad wire.
According to service manual, the C1A70 should be solved after the ABS codes, so I would think that I should continue to investigate the C1106.
Before I continue, I was wondering if someone could help me with the following questions :
1. Do someone has experience with these codes?
2. Is a problem with the sensor rotor common? How would I inspect that (with salt on the roads the hub rust on the knuckle and cannot be removed non destructively most of the time)? My idea was to use an oscilloscope to monitor the signal on the wires and compare left and right, but this would not tell me if the sensor or rotor or actuator is bad without a lot of parts swapping. Also maybe I can fit an inspection camera in the hole of the sensor.
3. If it’s not the rotor, the next step would be to replace the ABS actuator. This procedure asks for programming the steering angle sensor. Is the car going to work without this programming(at least to drive it to a dealer or someone with CONSULT)? Will a dealer do this after I replaced the parts myself? It seems to take like 5 minutes according to the service manual... Or is there a way to do it without CONSULT ?
Thanks!