Recent content by pthack

Any newer Wholesale values for the 2015 SV's available?

Does anyone have the dealer license needed to go to the Manheim auctions in the Portland, OR area? I'd like to see what Leaf's are available there, but it's a dealer only auction..... Pete.

Just to let you know. 0.34.51 (on my Sprint Note II) does NOT initialize the battery voltage or kW (above the bar graph on screen 4), OR the temps (all are the same temps) until I go to screen 1 at least once.....once I do, the batt voltage and kW are updated, but never update again (they stay...

I never 'enabled' any new screens, just booted it up, let it pair to the elm327 (why it needs to re-pair everytime, when leafspylite just 'works', is beyond me...), and started to look at screens..... Still don't know why the power monitoring screen doesn tell you what units it uses.....says it...

Finally bought Leaf Spy Pro....but when I go to the screen (screen 5) where it shows brake power and other stuff, the program kills my ELM327 BT adapter looking like it's asking for '167 00' in the 'connected' status bar at the bottom right....I can go back to other screens, but they never...

If you're going to be there all day, then a 15A outdoor 120V GFCI outlet would be fine. That would charge you back up about 32-35 miles of range in the 8 hours plugged in at work...bringing you to just about full again.... It's cheap, and they could do it with a high-quality extension cord...

Nah, the Jetson's car....

I still have 14 mo left on my 24 month lease of my 13 S (w/QC). If I can extend my $99/mo lease another year, I WILL be a happy camper (especially since here in cool Pac NW, I don't see expect lots of batt degradation...)

Personally, I think just about every sit-down restaurant/mall/theater in the country ought to put in AT LEAST 2-4 L2 chargers. You use a credit card to 'start' charging, at about $2.50/hr ALL THE TIME you are plugged in..... HERE'S the NEW PART..... Have an RFID or 'smartcard' reader on...

Ok, so when this new code comes out, what do I need to re-flash mine? I've been having the same problem somewhat intermittently.....if this helps at all, when it happens, (and I notice), if I unplug the J1772, then replug it in, I do NOT hear the relay 'click in' to charge.....but if I don't...

2nd the motion....especially if it was actually speed-sensitive....

Here in the Pacific North West (24-26 degrees during driving times), with pre-heat, leaving the house at 98% on the SOC display, I'm still getting 68 miles with 72 degree HEAT setting at least 50% of the time, and driving 58 miles of that at 65-69 mph (indicated...62-66 actual)... Mainly flat...

Not sure.....I don't use the charge timer, just the heater timer....Got out to the car well before it would have started, and got in to check the charge.....it wasn't fully charged (I charge to 100%, and it was at 78%), so that's when I tried the unplug car, then replug, and didn't hear the car...

Here's a question..... Had a power failure while charging (entire area for 8 hours)..... When I got up in the am, (now with power), the leaf was NOT fully charged. Unplugged and replugged, and it still didn't start charging again..... Had to POPO (Power-Off,Power-On) the breaker going to...

I just hit the 'call' button again (while it's speaking' and it shuts up and waits for my response..... I have an entry in my phone for home called 'home home' (since one of my other bluetooth headsets won't call entries with only 1 word in them), so I just: hit 'call' button. once it starts...