coolfilmaker
Well-known member
- Joined
- Jul 18, 2011
- Messages
- 319
I've now found out that after setting up timers on my blink I have to power cycle it to get them to work now. Release the damn 2.0 firmware!
garygid said:Reboot your Blink by unplugging and re-plug?
saintyohann said:Are you getting error 8, -1? Me too.
linkim said:It was too cold in the garage to play around with the display to see if anything else is different.
waitingforaleaf said:If your local network connection is working, you can check it from your network connected computer by inputting the appropriate IP address (found on and password (default password is "blinkadmin" I believe). Unfortunately, on my unit, this function is causing errors (http error codes) since it upgraded to 2.0. It was working perfectly fine on 1.8 earlier.
Enter your email address to join: