Search results

Where can I find a male connector for the hv battery for the vehicle side? Like to find a replacement. Is there somewhere that sells it? I have a 2012 leaf.

Why?

Is there a splice kit that would allow me to tap the positive and negative connection and add a pack of 5 different packs I put in my trunk in a big plastic box with some foam pads?

Could anyone help me find/make a splice kit for the leaf to add a extender battery? I just need some 4guage wire and the male and female port right? Also a three way crimp kit for 4guage wire? Idk where to find that though? Anyone have any notes? Really trying to get my leaf going more than 40...

Is there an adapter I can add between the hv connector (between battery and vehicle) to add this extender? And how much range could I get from adding it?

What about five in the trunk connected in parallel to the original battery as an extender?

So I was wondering if there was an adapter that would split the power from the battery to the car so I could add a second battery without putting it on a lift and dropping the pack.

US $66.66 33%OFF | 3.7V 114Ah/120Ah CATL NCM Lithium Ion Prism Rechargeable High Capacity Battery for DIY RV Solar System Boat Scooter Battery Pack https://a.aliexpress.com/_mtuqYow Is this something I can use instead of the cells made by Nissan?

Anyone know of a high voltage contactor that will work for turning off the 360v? I need one between each cell pack so I can charge them with 72v chargers. Need 110/240v ones so I can wire it to the charge port. I think that should work they have independent bms units I think. I just need dpdt...

https://www.ebay.com/itm/383276816832?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=5-67Qmx9QE-&sssrc=2349624&ssuid=pdt6GyGETvi&var=&widget_ver=artemis&media=COPY Is there a reason I can't wire 5 of these in series? Get 360v and get this rig Rolling? I have a 2012 Nissan leaf. Can I somehow...

Where can I get a 360v bms for making a pack? Was gonna see if I can stick one in the trunk.

Or add extra cells to raise the voltage so it's not under the voltage limit? Idk.

So I haven't seen any updates, but is there a way to change the bms to ignore the low battery warning? Just force it to work? Ignore turtle mode? Is the bms and Motor controller one unit? Or are they separate? Like can you just make an Arduino provide information saying it's charged constantly...

So how would one go about creating a battery pack with 18650 batteries and getting a bms to manage the pack, then installing it into the vehicle? Because this seems like the way to go. They seem cheap enough. Cheap ish.. and the car is old and needs a new pack. Where can I get a bms that can...

Where can I buy this?

So if I may ask, which specific part is making the clicking noise? And where is it physically located? Like if you need to replace it what would need to be replaced?

So how would you replace the controller with one that would ignore all battery warnings so it can be replaced by any battery pack?

I find it hard to believe theirs no way to just make the controller ignore the battery warnings.

Converting the leaf to what? Something that can use 18650 cells?

So basically some 2x4, a gas tank jack and some regular jacks and stands.