From the bottom photo working up:
L500 = Surface mount common mode CAN Buss filter inductor; example part link , another example pdf
D400 = Zener diode (marking code G2);
R8000 = zero Ohm surface mount resistor (a jumper);
D108 = surface mount signal diode; can't see marking code in the photo.
Also the circuit board trace from CN100 pin 9 (CNTRL) needs to be repaired/patched either with solder or with a piece of 30AWG copper wire.
Might be easier to just do the fast charge upgrade as Dala has documented
I say might. If you can figure out how to get fast the charge PDM working on a J1772-only Leaf--that would be terrific. My white Leaf is J1772 only, and the PDM is the only part I really worry about having to replace due to the excessive cost.
Can't see a marking code on the diodes in the picture. Can you see any code on the device if you shine a light from the side?D108 picture from Fast Charging PDM
Enter your email address to join: