Recent content by ybpvin

Dear 49thdiver, you have done a great job. I can't start the charger yet either. Could the PDM use the motor as a transformer? Second point. When the PDM module is started on the working machine, a quiet whistle of the converter is heard. I think it might be using some command CAN.

I also ask you to send me a code for testing. I connected all the wires, but charging does not start. My E-mail: [email protected]

Pre-charging relay is necessary! I use two 220 volt incandescent lamps connected in series. If you connect a high-voltage battery without prior charging, there will be a short circuit for a short time. PDM can go into protection mode.

@TrueSoln, Very much hope for luck))

Colleagues, did anyone manage to run PDM to charge a high-voltage battery?

For the test, I connected a high-voltage battery without a relay to the pdm unit. Charging 12 volts battery starts and infects up to 14.4 volts.

I borrowed my native charging unit from the Nissan Leaf for the test. Wires are connected according to standard scheme. Can-data I recorded from a serviceable car. Edited and removed the ID that forms the engine. But battery charging is not going on.

We assembled the installation on the car, as shown in the video. PDM unit and engine. I put together a can-translator and connected to the installation. The high voltage battery is connected directly. We used Consult 3 to diagnose the errors. When PDM is healthy and working, a quiet whistle is...

@TrueSoln, I have a similar problem. The charger starts, there are no errors, but charging does not go ((

Without a cooling system PDM Leaf 2013- 2017 heats up 10 minutes to 80-90 degrees Celsius and limits the current to 5 A, I personally checked on the car.

@TrueSoln, Very interesting information. I want to test today too, but in the data stream I didn 't have id-14d. What is the syntax of this command?

@nlspace, We use three relays to turn off the battery. Two main and pre-charge relays. But I cannot start the charge of the high-voltage accumulator ((. Pdm starts, but the charge does not go. I live in Ukraine.

I put together the pdm module plus the engine. Pdm infects a 12 volt accumulator, but I can 't infect a high voltage battery. I took the stream off the working Nissa leaf 2015. Removed id from the tray that forms the motor. Everything starts, there are no mistakes, but the charging is not going...

Kind time! I want to implement a counter algorithm from 0 to 3. E celeron55 on the page has an algorithm of 0x07 | (counter < < 6), but I cannot implement it. How do I write the code correctly?

I submitted different data streams to the channel: 1. a clean stream taken from a working car. 2. A stream with emulation of a current and voltage sensor. 3. Stream with data from the motor, etc. The charging device starts, there are no errors, but the battery does not charge (( Perhaps the...