Recent content by tomdickmeyer

Today I was using LSP to monitor my EV conversion while giving it one of it's first test drives (it uses Leaf Gen1 motor, inverter and battery". When I looked down at LSP screen one that shows the 96 cell voltages the screen showed "0 L" at the top (to the left of the cell mv diff value" which...

Please ignore my question, I just made a dumb mistake. I'm seeing the 0x79b 0x7bb messages now!

I have LeafSpy Pro reading my Gen1 battery voltages and expected to see all kinds of 0x79B and 0x7BB message traffic on my canbus monitor (I am monitoring traffic using a Seeed canbus shield and Arduino One). I see some messages initiated from the LBC and the Inverter but not from LeafSpy. I...

Can someone out there that has a Gen1 OBC on the bench look at R897 and tell me its value? It looks like mine has fallen off and needs to be replaced; mine looks like a component used to be soldered on the board. R897 is located inside the Gen1 OBC on the bottom of the top board. I have...

I have been troubleshooting my Gen1 OBC and it looks like the control board has R897 missing. Can someone look at their board and tell what the value is supposed to be so I can replace it? It is located on the bottom of the board near IC509. TIA for any help. TomD

@ETrrijal2 Did you ever get the OBC for Gen1 working? I am new on the forum and new to Arduino. I have my Gen1 OBC wired on the bench, and i have an Arduino UNO with a Seeed Can-bus shield. I am seeing the 0x380 and 0x5BF messages. I do not have the HV Battery or the LBC connected yet; I have...