Recent content by eBIMMER

I've downloaded the DB tool - thank you for linking me to this. It will be incredibly helpful! I'm editing this post based on your last reply. Thank you for the help. My removed post suggested scaling by 0.641 so max value would be 10,500 which I believe is the max speed of the motor...

I have been struggling a little bit to get my values to read properly. I hope somebody here who understand byte processing can help tell me what I'm doing wrong. The Arduino code that interprets my RPM value is below: RPM = (rxBuf[4] << 2) | (rxBuf[5] >> 6); But this outputs RPM values that...

Thank you for the reply. I am very new to working with Canbus and interpreting bytes, etc. Based on your input it sounds like the problem must be in my code and possibly the way I'm handling the values. I adjusted a bit shift, removed scaling, and will see what sorts of values I get. I am...

So CanBus message on bytes 4 and 5 of 0x1DA reads RPM. Does anybody know the proper scaling for this value to get actual RPM of motor? I use the Leaf system in another vehicle without the gearbox so it is a little harder to figure it out mathematically. Multiplying x10 is too high, as the...

I wanted to use the Nissan pump for cabin heat to circulate the fluid thru the heater core. I already have the stock pump so I thought I'd try to use that. Yes, in many ways it would be easier to buy a pump off the shelf. My motor cooling pumps are the stock Nissan pumps. The can system runs...

Hello! Does anyone know what signals are required to run one of the 12 water pumps in a 1st gen Leaf? There are 3 pumps in the vehicle and each has 4 wires. I measure one of the wires as being about 13V (slightly higher than battery actually). Other wires when measured with a DC multimeter...

Hi everyone, first post! Don, how were you able to get Leaf Spy to reset your parking brake zero point? I'm looking for that capability but can't find it. Thanks!