Recent content by des28

You may be able to follow the tracks from the pins, or look for this same chip as in the attached image, resistor is likely to be right beside it on pins 2/3 as it is with this one. You can measure the 120 ohm / 20 ohm right at that point too. Cheers, Des

That's a little odd. I guess that is relying on a similar resistor at the other end to do the job instead. I did actually look up the datasheet of that particular chip and noticed they described a test circuit that used a 60 ohm resistor between the 2 pins, I guess that makes sense if in normal...

Ha, I'd just taken pictures and came back here to post them! Wouldn't you need to replace that with a 120 ohm resistor rather than just removing it?

Hi, Thanks for posting this, just tried mine and it's 20 ohms. Got it from aliexpress. Haven't used it yet as my Leaf is still to arrive (just got loaded on a ship in Japan tonight!) I would open it up and post a picture for you, but can't get into it as don't have the right size hex bit to...