doggyollie
Member
Did you receive the unit and will it help with the app?
Thanks!
Thanks!
I bought what looks to be the same device from ebay seller "l.g.brother":Turbo3 said:I have had the best results with the 'Mini'.DougWantsALeaf said:Will any version/maker of ELM327 OBDII OBD2 Bluetooth work with Leaf Spy?
So, if I can verify with a seller that the ELM327 has 3 boards instead two, this would be indicative of a V1.5 - correct?Turbo3 said:For now I would stay away from any ELM327 listed as being v2.1. For clones this means a cost reduced version as there are only 2 circuit boards inside instead of 3. Being listed as v2.1 does not mean it supports the official v2.1 AT command set or even the v1.5 command set.
princen said:I have several ELM327 devices that are sold as 1.5 but are reported by the app as 2.1. So no luck to get them working
Will the Scantool BDLINK LX work? While more expensive, I can at least rely on it being genuine.
Yes, it comes up as V1.5 on the Leaf Spy screen.doggyollie said:Let us know if it is v1.5 Gary. I am still withholding purchasing another as I have ordered to v2.1 and I'm hesitant to get another unless I know it is 1.5.
Thanks!
It is described in the built-in Help. Go down to the Battery Status section then to the Middle Section description. The default Red bars are when the shunt is active for that cell therefore draining a small amount of energy to balance the cell with the others.Scubamal said:Can anyone tell me what the difference between the blue and red bars on the 96 battery graph?
electricvw said:Are there any reports of the Galaxy 5s NOT working with this setup? I can't get either OBDII device to communicate with my Leaf. How do you know the Version of the Device? One of my devices should be V2.1 and the other is supposed to be V1.5. Neither one will talk to the Leaf Spy Lite or Pro.
Did you first pair your Bluetooth OBDII devices with the 5S before starting Leaf Spy Lite?electricvw said:Are there any reports of the Galaxy 5s NOT working with this setup? I can't get either OBDII device to communicate with my Leaf. How do you know the Version of the Device? One of my devices should be V2.1 and the other is supposed to be V1.5. Neither one will talk to the Leaf Spy Lite or Pro.
Use on the PC software version is V2.1,use via phone software version is V1.5,also hardware is v1.5
Has to be connected during the drive.shalvak said:Hi,
I have a question regarding Leaf Spy (Pro) and the option to log data. Does the OBD-Conntector have to be plugged in during the drive or is it fine to plug it after the drive?
TimLee said:Has to be connected during the drive.shalvak said:Hi,
I have a question regarding Leaf Spy (Pro) and the option to log data. Does the OBD-Conntector have to be plugged in during the drive or is it fine to plug it after the drive?
Enter your email address to join: