Recent content by hubaksis

Thank you for the details. Leaf Spy doesn't show anything for e-NV200, Gen-2 30kWh UK and Japan versions when they are OFF and charging. I'll check the behavior with the break pedal.

Thank you for the details on your project. Can you tell me what happens when you send 0x68c message over CAR Can? Any chance that you have a log of messages that are send over the CAN bus when you wake it up? I am trying to get details about charging (battery temperature, cell voltage, etc.)...

Ok, thanks. If I find anything about e-NV200, I'll post about it. Right now it works similar to Gen-2. Almost. However, I can't find QC count. It's not the same like Nissan Leaf. Right now it's the only difference. I'll check it with the break pedal. By the way, the same thing happens to Gen-2...

Update: The same thing happens with Gen-2. 0x68c message over CarCAN doesn't make any difference. It seems that it wakes up for 2 seconds, but there is still no response for the 0x79b request. Is there any way to get data while charging?

I have an issue when I scan e-NV200 van using LeafSpy Pro or just requesting data with arduino. It doesn't work. It works only while I drive, but not while charging. (by the way, the Fast charge counter in LeafSpy is always 0) I connected to the CarCAN with arduino and found out that there are...

Hi everyone, I think this is the best topic to ask. I found out that some values can be requested from a module only after setting it into diagnostic mode by sending a command 02 10 C0. However, I can't find any details about this mode. Can you tell me, does it have any expiration time? If so...